Page 1 of 1
QL Monitor Lead
Posted: Fri Apr 17, 2015 8:45 pm
by RWAP
Does anyone know what monitor had a 9 pin D socket connection on it for the RGB signal from the QL - see picture
Re: QL Monitor Lead
Posted: Fri Apr 17, 2015 9:14 pm
by tofro
Rich,
EGA monitors used to have 9-Pin D-Subs on them.
Tobias
Re: QL Monitor Lead
Posted: Fri Apr 17, 2015 9:32 pm
by chriskgnr
or maybe a Commodore 1083s, like the one i use!
Re: QL Monitor Lead
Posted: Sat Apr 18, 2015 10:25 am
by RWAP
Ah right - I have only ever seen the DIN sockets and SCART like connectors
If anyone wants the lead feel free to give me a shout!
Re: QL Monitor Lead
Posted: Sat Apr 18, 2015 12:53 pm
by Derek_Stewart
Hi Rich,
I have a CM8833 MkII Monitor, which may this type of monitor lead.
Re: QL Monitor Lead
Posted: Sat Apr 18, 2015 1:20 pm
by 1024MAK
There were some multi sync CRT monitors that also had 9 pin D connectors (for EGA and VGA modes).
Mark
Re: QL Monitor Lead
Posted: Thu Aug 06, 2015 12:59 pm
by Derek_Stewart
RWAP wrote:Does anyone know what monitor had a 9 pin D socket connection on it for the RGB signal from the QL - see picture
013.JPG
Hi Rich,
I have to make a QL monitor lead for my CM11342 aka CM833-II
According to the monitor manual, the 9 pin D connector on the rear of the monitor accepts Analog and TTL RGB.
Your lead maybe for this type of monitor.
I will construct the lead and report back.