DOM
Posted: Sat Oct 31, 2015 9:13 pm
Anyone know if a DOM (Disk-On-Module) would need a separate power supply when used with Qubide on QL?
Page 1 of 1
Re: DOM
Posted: Sat Oct 31, 2015 9:33 pm
Nope, I use one on my qubide clone
Re: DOM
Posted: Sat Oct 31, 2015 9:59 pm
Yes, as Peter has pointed out, DOMs normally have a non-standard IDE connection that connects them to +5V. The QubIDE re-make supports that.
If you want to connect the DOM to a PC, however, you will usually need a separate Power Supply - Normal USB-IDE adaptors do not normally supply the DOM on this Pin. I use a separate USB connection to the Mac to supply the voltage.
Regards,
Tobias
If you want to connect the DOM to a PC, however, you will usually need a separate Power Supply - Normal USB-IDE adaptors do not normally supply the DOM on this Pin. I use a separate USB connection to the Mac to supply the voltage.
Regards,
Tobias
Re: DOM
Posted: Sun Nov 01, 2015 10:14 am
Hi,
I have a 1Gb DOM in my Quibide, partitioned to 4 x 256Mb paritions.
It works very well without a power supply.
I have a 1Gb DOM in my Quibide, partitioned to 4 x 256Mb paritions.
It works very well without a power supply.
Re: DOM
Posted: Sun Nov 01, 2015 9:33 pm
Hi
Many DOM and IDE adapters ( CF-IDE or SD-IDE) use IDE pin 20 ( an unused pin of standard IDE port) to get power.
My qubide clone has this functionality
Bye
José Leandro
Many DOM and IDE adapters ( CF-IDE or SD-IDE) use IDE pin 20 ( an unused pin of standard IDE port) to get power.
My qubide clone has this functionality
Bye
José Leandro