The Sinclair QL Forum

The centre of the holes?

Good point Brad.

Yes, to the centre of the holes.


Cheers,
Norm.

Cheers. I’ll forward that on

NormanDunbar wrote:Hi derek,

Derek_Stewart wrote:I could do a quick STL file to give some sort of solution for this.

If you are doing an STL file, the holes are 3 mm from the base of the plug in section. I forgot to put that somewhat important measurement on the diagram.


Cheers,
Norm.

I do seem to a little time at present, I can do a 3D model and output STL

The original plug in encapsulated , clearly this can not be made, a split case with the terminal sockets maybe the best way forward.

Maybe part of making a new power supply, based on existing circuit design posted earlier on the forum.