OkRWAP wrote:On q-emulator (at least) there are some oddities (blank pixels) around 20 seconds.
You cheated on the FILL command - you used just the first 30 seconds....How about showing it for a minute?
Disbelief at first, as I had this working correctly on my set up, so he are the responses.
1: You cheated on the FILL command - I dont understand, I used the fill command as stated in the book Fill 1 : draw : Fill 0
2: You used just the first 30 seconds - I only wanted the first 30 seconds, Countdown
3: On q-emulator (at least) there are some oddities (blank pixels) around 20 seconds - No there weren't!, I use QemuLator for all my programming. I never noticed any stray pixels......
My setup on Qemulator always loads SMSQE code before I do anything, mainly just so the recall of commands is easily obtained using the cursor keys (SMSQE only). The commands I used in the listing are all standard and nothing special so there should be any difference. I checked and there is.
Odd pixels occur at and after 20 seconds on bare Qemulator both modes, but with SMSQE installed it does not occur. Anomaly?
I then checked it on QPC4 and this also works as expected (once wtv: paper 7: cls was put in line 1010
again with no stray pixels.
So SMSQE has slightly different calculations and hence graphic effects compared to QL standard.
Interesting